Metapace L-3 Manual de instrucciones descargar pdf (Pagina 31)

READY and RIBBON Lamps blink simultaneously

Possible Cause Recommend Solutions Remarks

Run out of ribbon Load a roll ribbon

Ribbon jam Clear the jam

Ribbon Sensor

error

Service Ribbon Sensor To be serviced only

by qualified

personnel

Only READY Lamp blinks

Possible Cause Recommend Solutions Remarks

Serial I/O error Check Baud Rate settings

in Setup Menu

Memory overflow Restart the printer

Perform Reset

Miscellaneous

Vertical blank lines

Continuous vertical blank lines in printout indicate a dirty or faulty

printhead as shown below:

If the problem cannot be solved by cleaning the printhead, replace the

printhead.

The host shows ‘Printer Timeout’

1. Check if the interface cable is connected.

2. Check if the printer is turned on.

If the situation remains unsolved, please contact your reseller or our

customer service engineer.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Sin comentarios

Metapace L-3 Manual de instrucciones Pagina 31